★ 5.0 RatedCentral Alberta's full-service residential contractor
Concrete flatwork in a Central Alberta residential neighbourhood served by JFK Surfaces

Blackfalds & Penhold · Flatwork

Flatwork done right the first time.

Driveways. Patios. Walkways. Garage slabs. RV pads. Every horizontal pour a house needs, sized and reinforced for what actually goes on it. Serving Blackfalds, Penhold, and the growing subdivisions between them.

10+

Years pouring concrete

2

Towns, one crew

BBB

Accredited business

JFK Surfaces & the bedroom towns

Blackfalds and Penhold are growing fast.

Blackfalds is one of Alberta’s fastest-growing towns. Penhold has been building steadily for over a decade. Both are full of newer builds where the landscaping, driveways, patios, and shed pads are still a work in progress — and older homes where the original concrete is finally ready to come out.

We’re a Central Alberta contractor based on Highway 2A between Red Deer and Innisfail. Blackfalds is 15 minutes north of us. Penhold is 10 minutes south. We pour flatwork in both towns every season and know the subdivisions, the ready-mix suppliers, and the town Development Officers by name.

We won’t quote flatwork from a phone call. Every yard is different. We come out, walk it, and give you an honest number in writing. Free, no pressure.

What flatwork we pour

Every kind of residential slab.

01

Driveways

New pours and full replacements. 4-5" residential slab, wire mesh or rebar, air-entrained mix, sloped for drainage away from the house.

02

Patios & entertaining pads

Backyard patios sized for a table, seating, BBQ. Broom finish, stamped patterns, or exposed aggregate for a step up.

03

Sidewalks & walkways

Front walk to the sidewalk. Side walk to the back gate. Garden paths. Poured with proper expansion joints so freeze-thaw doesn't tear them apart.

04

Garage floor slabs

New detached-garage floors, garage floor replacements when the original has heaved. 4-5" on compacted base with mesh or rebar.

05

RV pads & trailer parking

6" pads with heavier reinforcement for RVs, boats, trailers. Sized to your unit, sloped so meltwater runs off the pad.

06

Shed & outbuilding slabs

Slab-on-grade pours for storage sheds, workshops, and outbuildings. Sized to what the town Building Permit says the structure needs.

Why the prep matters

Flatwork lives or dies on what’s underneath it.

Base. 4-6 inches of road crush or 3/4-down gravel, compacted in lifts. In-town Blackfalds and Penhold soils are mostly clay-till — they heave hard when they freeze. Proper base is what stops that.

Reinforcement. Wire mesh for lighter residential pads. #4 rebar on 18-inch centres for driveways and garage slabs. Placed on chairs so it stays in the middle of the slab where it actually does something.

Mix & air. 32 MPa air-entrained mix for exterior work. The air bubbles in the mix let the concrete expand and contract through freeze-thaw without spalling.

Joints. Saw-cut control joints at proper spacing (roughly 2-3x slab thickness in feet). Concrete cracks — what we can do is control where. Missing joints is the reason so many DIY slabs have random cracks everywhere.

Cure & seal. Curing compound sprayed on the fresh slab. No traffic for a week. Penetrating sealer at 28 days. That’s the difference between concrete that lasts 20+ years and concrete that’s falling apart in five.

How we work

Simple. No surprises.

01

Call or text

Tell us what you're pouring and roughly how big. A photo helps.

02

Site visit

Free walk-through. We look at access, grade, base, drainage.

03

Written quote

Real number in writing with scope, thickness, rebar, timeline.

04

Poured right

Prep, rebar, pour, finish, cure, seal. Clean site.

Who you’re calling

Local. Licensed. BBB accredited.

JFK Surfaces is a Central Alberta family-run contractor founded in October 2018 by Fabien Joseph Quesnel and Kyla Peters. We’re based on Highway 2A in Red Deer County — short drives to both Blackfalds and Penhold.

Licensed. Insured. WCB covered. BBB accredited. Fabien has 10+ years of trade experience. Every pour is quoted, prepped, poured, and finished by our crew — not subbed out.

“We had an old cracked driveway, no back walk, and no RV pad. Fabien did all three as one project. Clean crew, honest numbers, dead-flat slabs.”
— Blackfalds homeowner

Common questions

What Blackfalds & Penhold folks ask us most.

What is concrete flatwork?

+

Flatwork is the industry term for any horizontal concrete slab — driveways, patios, sidewalks, walkways, garage floors, basement floors, garage aprons, RV pads. Basically, anything you walk or drive on. It's distinct from foundations, footings, or vertical concrete (walls). Most residential concrete work in Blackfalds and Penhold falls under flatwork.

What drives the cost per square foot for concrete flatwork?

+

The four big drivers are thickness (a 4-inch driveway vs. a 6-inch shop floor), reinforcement (mesh vs. rebar), base prep (existing gravel vs. strip and compact new road crush), and finish (broom vs. stamped vs. exposed aggregate). Access, saw-cutting old slab, and site drainage add or subtract from there. We quote per-job, not per-square-foot averages, because the numbers vary so much.

How long does concrete take to cure in Alberta?

+

Concrete gains most of its strength in the first 7 days and reaches full design strength at 28 days — same everywhere. What Alberta adds is the temperature challenge. In warm weather we can walk on it after 24-48 hours and drive on it after a week. In cool weather we blanket the slab and delay traffic. In freezing weather we don't pour without heated blankets and hot water mix — cold cure destroys concrete strength.

Do I need a permit for a garage slab or RV pad in Blackfalds?

+

In the Town of Blackfalds, a new garage or building over 10 sq metres typically requires a Development Permit and a Building Permit. A standalone concrete slab (like an RV pad) without a structure on it often falls under Development Permit review depending on location, coverage, and setback. In Penhold, the process is similar through Town of Penhold Planning. We check with the town's office before quoting.

Can you pour concrete flatwork in the fall in Central Alberta?

+

September and early October are usually fine. Late October through early November is workable with cold-weather protocol — hot water mix, insulated blankets, extended cure time. Once overnight lows drop below freezing consistently, we stop pouring exterior flatwork because the cure suffers and the concrete's long-term strength takes a hit. Better to wait for spring than to pour a compromised slab.

Do you pour concrete for new-build homes in Blackfalds and Penhold?

+

Yes. We work with individual homeowners and general contractors on new-build driveways, garage slabs, front walks, and back patios. If you're building in Aspen Lakes, Panorama Estates, or the Blackfalds/Penhold subdivision growth, we're already working in those areas.

Do you handle old slab tear-out and replacement?

+

Yes. Saw-cutting, breaking, hauling, and disposal are included in most replacement jobs. Older Penhold and Blackfalds homes often have 30-40+ year old driveways or walks that have heaved past repair — full replacement with proper base and reinforcement is usually the right call rather than repeated patching.

Building a detached garage in Blackfalds? See detached garages in Blackfalds or the full concrete services overview.

Blackfalds & Penhold flatwork quote

Come look at your project. Free.

Driveway, patio, garage slab, RV pad — call or text and we’ll come measure the area, look at access, and give you a real number.

Call Fabien(236) 880-3675Text a photo(236) 880-3675